FlexShade® ZIP 127 with Solar Panel
The FlexShade® ZIP 127 with Solar Panel offers a fully integrated, pre-wired motor, battery, and solar panel solution—no line voltage required.
FlexShade® ZIP 127 with Solar Panel provides a plug-and-play solution for motorized roller shades, integrating a quiet DC motor, solar panel, and embedded battery in a pre-wired system. No line voltage connection is required, making it ideal for applications where wiring access is limited. Engineered for performance and energy efficiency with advanced power management algorithms to enable charging even without direct sunlight. Built-in adjustable wings optimize solar panel orientation. Key features include soft-start/stop, intermediate positions, and smart home or radio control. Welded ZIP fabric and unique side channels form a sealed enclosure, ideal for garages, patios, porches, pool houses, and outdoor commercial food service areas.
Product Specs
-
Available in sizes up to 16' wide x 10' high (488 cm x 305 cm), depending on fabric selection.
-
Uses ZIP 127 headbox: 5” H (127 mm) headbox. Three Headbox Styles: angled, curved, and square.
-
Fully integrated DC motor, solar panel, and high-capacity battery in a pre-wired system.
-
Battery is housed in the solar panel, not in the shade roller.
-
Quiet motor operation with soft-start and soft-stop functionality.
-
Charges even in indirect sunlight using advanced power management algorithms.
-
Up to 35 days of battery life with standard use (2 cycles/day).
-
Supports smart home or radio control systems.
-
Side channel width is only 1-5/8" (42 mm). Side channels can be jamb or face mounted.
-
Fabric is retained in side channels by continuous coil zipper retention system.
-
Hardware features powder coat finishes with a lightly textured surface in black, ivory, bronze, white, sand, and slate. Custom powder coat colors are also available.
-
Weighted hem bar to stabilize shade during operation.
-
Compatible with Bond Bridge Pro and Breeze Pro wind, rain, and sunlight sensor.
ANSI/WCMA A100.1-2022 Child Safety Standard
Effective June 1, 2024, in compliance with the updated ANSI/WCMA A100.1-2022
child safety standard, all Draper® window shades operated by a bead chain will be
furnished with a tensioned hold-down device that is permanently attached and
partially disables the product if not installed correctly. This hold-down should
be installed with tension on the chain.
All bead chain operated window shades will include:
- Permanently installed spring-loaded tensioned hold-down device
- Approved permanent warning label attached
- Approved mechanical fasteners for the tension device included. Screws provided are not suitable for all mounting surfaces. The installer is responsible for secure mounting using
appropriate hardware for the site conditions. Consult with contractors and builders as needed.
If the tension device is not installed with appropriate tension on the bead
chain, the shade will be rendered partially inoperable. If installed
properly, the tension device will prevent the creation of a hazardous loop
and
will maintain tension on the bead chain.
Approved permanent warning label
Learn more about the new child safety standard
At the link below, you can see more information about the new child safety
standard, mounting methods for the tensioned hold-down device, alternatives
to bead chain products, and more.
Click here for more information
Tensioned hold-down device
Supporting Documents
Click the
and
icons to navigate the folders. Click the document name to download.
Part Numbers