Dual Roller Pocket Headbox

The Dual Roller Pocket Headbox features the ability to vertically stack two fabric shades in a single recessed headbox leading to design solutions that optimize a project space. The headbox allows for ease of installation during the construction phase, saving shade roller set-up for later.
  • Two complete shades vertically stacked within a single recessed headbox.
  • Standard size is 5-¾ (15 cm) deep x 7-¾” (20 cm) high for all manual shades and most motorized shades. Dual Roller Endcaps used for this size.
  • Size for large motorized shades is 6-½” (17 cm) x 8-½” (22 cm). Ceiling brackets used for this size. Available with or without tile lip.
  • Available with or without tile lip.
  • Dual Roller Pocket headbox is white (standard) or grey where visible at the ceiling line.
  • Suspended or flush mounting available.
  • Shades may be coupled, minimizing wiring and motor use (not suitable with LightBloc).
  • Accomodates: Motorized FlexShades®, Clutch FlexShades®, Battery Powered FlexShades®, 24V FlexShades®, and LightBloc w/Side Channels.
  • Headbox may be installed in ceiling in advance of shades.
  • Product designed for interior use.

If clutch-operated roller shades are installed in an environment where it's possible that young children will be present, they should comply with ANSI/WCMA A100.1, the Standard for Safety of Window Coverings.

If the shades that you purchase need to comply with this standard, it is your responsibility to inform Draper and opt-in to receive compliant products at time of order.

Compliant window shades will include:

  • Pre-installed spring-loaded chain tension device with bead chain threaded through it
  • Approved permanent warning label attached
  • Approved mechanical fasteners for the tension device included

If the tension device is not installed properly, or becomes unattached from the mounting surface, the shade will be rendered partially inoperable. If installed properly, the tension device will prevent the creation of a hazardous loop and will maintain tension on the bead chain. The tension device and label require tools to be removed.

Testing

The testing required by the WCMA for products to comply with safety standard A100.1 includes:

  • UV stability testing - AATCC Test Method 16 for UV Stability
  • Impact testing - ASTM D5420
  • Bead chain durability testing
  • Operation cycle testing - 3,000 cycles per the standard

Draper's spring loaded tension device passed the requirements of these tests.

WCMA compliant hangtag warning label
 
  • C177.249SA - Dual Roller Pocket Headbox, Manual Shades
  • C177.248SA - Dual Roller Pocket Headbox, Standard Motorized
  • C177.250SA - Dual Roller Pocket Headbox, Large Motorized
  • - Contact Draper for details

Quick Feedback

We would love to get your thoughts so don't hesitate to send us your feedback!

Name
Email
What could we improve? (required)