Product Specs
-
Compatible with 2” (51 mm) and 3” (76 mm) diameter rollers. Adjacent roller tubes must be the same diameter.
-
Brackets extend 2-1/2" (64 mm) from mounting surface to center line of roller and may be wall- or ceiling-mounted.
-
Coupler system should be installed in an existing pocket or a Type D Pocket. Fascia is available.
-
Coupled units may be installed in 4-5/8” (117 mm) Draper ceiling pockets. Fascia is available.
-
Only motor and crank-operated shades are suitable for coupling. FlexShade 2, Colossal, and LightBloc FlexShade may NOT be coupled!
-
Also available for Dual Roller Motorized FlexShade.
ANSI/WCMA A100.1 Compliance
If clutch-operated roller shades are installed in an environment where it's possible
that young children will be present, they should comply with ANSI/WCMA
A100.1, the Standard for Safety of Window Coverings.
If the shades that you purchase need to comply with this standard, it is your
responsibility to inform Draper and opt-in to receive compliant products at time of
order.
Spring-Loaded Cord Tension Device
Compliant window shades will include:
- Pre-installed spring-loaded chain tension device with bead chain threaded
through it
- Approved permanent warning label attached
- Approved mechanical fasteners for the tension device included
If the tension device is not installed properly, or becomes unattached from the
mounting surface, the shade will be rendered partially inoperable. If installed
properly, the tension device will prevent the creation of a hazardous loop and
will maintain tension on the bead chain. The tension device and label require
tools to be removed.
Testing
The testing required by the WCMA for products to comply with safety standard
A100.1 includes:
- UV stability testing - AATCC Test Method 16 for UV Stability
- Impact testing - ASTM D5420
- Bead chain durability testing
- Operation cycle testing - 3,000 cycles per the standard
Our spring loaded tension device passed the requirements of these tests.
WCMA compliant hangtag warning label
Supporting Documents
Click the
and
icons to navigate the folders. Click the document name to download.
Part Numbers
-
C177.058SA - Straight Line Coupler-Retractable Shaft Assembly for 2" Roller
-
C177.059SA - Straight Line Coupler Height Adjuster Assembly for 2" Roller
-
C254.006 - 2" Spanner Wrench for 2" Height Adjuster
-
C177.061SA - Straight Line Coupler Retractable Shaft Assembly for 3" Roller
-
C177.062SA - Straight Line Coupler Height Adjuster Assembly for 3" Roller
-
C254.007 - 3" Spanner Wrench for 3" Height Adjuster
-
C069.013 - Angled Coupler
-
- Contact Draper for details
Related Motors & Accessories