Draper Inc., Since 1902 Draper Home Page
About DraperSearch Draper's WebsiteDownload a Draper CatalogDraper's policiesContact DraperWhat's New at Draper
Draper's projection screensDraper's projector and plasma lifts and mountsDraper's home theatreDraper's window shadesDraper's athletic equipmentDraper's easels
 
  SGC4 Window Shade Control System
  Low voltage control system allowing control of up to 240 motors in groups of 4.

SGC4 Control System

Go Green
This unit is basically a GC4 packaged with an SC1 in an 8" x 8" enclosure.   
Brings down the cost of controlling individual motors, while enabling "smart" communications via BUS communications system. 
Suitable for commercial installations where individual motor control is not essential, but flexibility of control options and subgroup control is desired. 
You can program from virtually anywhere: no access to the electrical panel is required and there are no cumbersome DIP switches to set. 
In addition, you can program the SGC4 from many sources: IR Wireless Remote Transmitters, RF Wireless Remote Transmitters, Hardwired Key Pads with built-in IR receiver, RF Key Pads, RS232 systems, IP source.

Can be operated by any Draper input device.
Control Options
Control system overview

View/Download
 

IntelliFlex®:
GC4 Control SystemIsolating RelaySC1 IntelliFlex® Controller
SGC4 Control SystemSPGC4 Control SystemIntelliFlex® Control Options
IntelliFlex® ProgrammingIntelliFlex® Downloads
Shades:
MotorizedManualFlexShadesFlexShade CouplerFlexShade Panels
FlexShade HardwareIntelliFlex® Control SystemsShade FabricsHusky Spring Rollers
Copyright © 2006 Draper Inc. • 411 South Pearl Street, Spiceland, IN 47385 • 800-238-7999 • 765-987-7999 • All Rights Reserved
This page was last updated February 27, 2007.   Information provided on this website is subject to change without notice.
Other products and companies referred to herein are trademarks or registered trademarks of their respective companies or mark holders.