| |
|
Download
Catalog Page |
 |
|
Mounting Brackets, Endcaps—
For wall, ceiling or jamb installation. Optional white bracket
cover available for 1-5/8" bracket. Endcaps, not brackets,
are supplied with optional fascia and headbox.
Depending on type of shade, either headbox, brackets or endcaps
are standard.
|
|
 |
|
Fascia—
Extruded fascia hides hardware and
roller. May be mounted inside or outside with matching endcaps.
Available in black, white, ivory, bronze or clear anodized
finish. Color in picture may vary from actual aluminum. Color
samples available upon request. 3-7/8" or 4-5/8" high
as required.
See also Fascia for Dual Roller FlexShades |
|
 |
|
Headbox—
Complete extruded headbox is available in two styles:
surface mount to head, jamb or wall, and pocket
mount for ceiling recessed installation. Both in
sizes 3-7/8" or 4-5/8" high
as required.
|
|
|
 |
|
Type D Pocket—
For clean, ceiling flush installation,
use extruded Type D Pocket. With bottom closure panel in place,
only a narrow slot is visible.
.
|
PDF Drawing |
|
 |
|
Wall Clip with Closure—
Pocket already exists? Specify FlexShade
Wall Clip with a long or short closure. Wall Clip mounts to
the wall and bottom closure panel drops neatly into place without
fasteners, leaving a minimal slot through which the shade descends.
For sleek appearance, use continuous wall clip. Closure sizes
1-3/4" or 3".
|
|
 |
|
Couplers—
Draper's FlexShade Coupling System
lets one motor or crank operator drive up to four additional
shade rollers. Click here
for details
|
|
 |
|
Side Channel or “L”
Angle—
Prevent direct light gaps at the sides
of your shade fabrics by installing side channels or “L”
angles. Side channels
are 3/4" deep x 1-3/8" wide, mount to the jamb or
face of the window opening. “L” angles measure 1"
x 3/4" or 1 x 2-3/4" are available in black, white,
ivory, charcoal bronze or clear anodized finish and mount inside
the jamb.
|
|
 |
|
Use the SpecWizard to select and configure products and then generate a 3-part spec in Word, WP or RTF format. |
|
