Draper's FlexShade Coupling System lets one motor or crank operator drive multiple window shade rollers.
Reduce the number of motors required and you reduce the cost of the project and simplify the electrical portion of the contract.
The shades coupled together may be of different widths, but the heights must be the same.
FlexShade couplers work with both 2” and 3” diameter rollers; however, adjacent roller tubes must be of the same diameter.
Brackets extend 2-1/2" from mounting surface to center line of roller, and may be wall or ceiling mounted.
Brackets are installer-friendly, and can overcome walls that are not perfectly flat. 
Ideally, install FlexShade Coupling System in Draper Type D Pocket, or existing pocket. Fascia is available. (Not suitable with side channels.)
Coupled units may also be installed in 4 5/8” Draper ceiling pockets. Fascia is available.
Fabric height can be easily and independently adjusted.
FlexShade 2, Colossal, and LightBloc FlexShades may NOT be coupled! Only motor and crank operators are suitable for coupling.
Crank override not available on motorized coupled shades.

Use the SpecWizard to select and configure products and then generate a 3-part spec in Word, WP or RTF format.